You are not logged in.

#1 2010-06-01 03:58:06

wecbob
Member
Registered: 2010-05-31
Posts: 2

Re: 2008 Prowler 650

HI,  My son and I just bought a used 08 650 Prowler (only 430 miles) and have several questions.  The parking brake will not hold and I have adjusted the cable all the way and still no luck.  Any suggestions?

Any good places to  buy aftermarket or used radio and speakers?

It has a windsheild and top and  I would like to remove the windsheild for hte summer as it is hot.  Has anyone just removed the rubber seal and taken the windshield out and then repalced it in the Fall?  WE cannot remvoe the whoe frame as then we have to take the top off.

Finally, we did not get a manual and need to buy one--any suggestions.  Thanks for any help  GC

Offline

#2 2010-06-01 22:50:41

elmerkit
Member
Registered: 2010-03-18
Posts: 106

Re: 2008 Prowler 650

May be brake pads are worn out try to check it you can check ebay for good speakers about the windshield its really up to you but i would recommend not to remove it.

Offline

#3 2010-12-07 19:07:41

optimizer999
Member
From: Arizona
Registered: 2010-12-07
Posts: 1

Re: 2008 Prowler 650

I know this is an old post but you can fix the e-brake easily by making sure it is released (not set), then adjust the cable at the lower end to allow the max slack, then you have to re-clock the arm but removing the nut and make a witness mark with a Sharpie pen on both the shaft and the arm to use as a starting point.  Then remove the arm and rotate it away from the cable only a couple of splines.  It doesn't take much.  Slip the arm onto the splined shaft and adjust the cable to take up any slack.  Try applying the e-brake and try to push the car to see if it is holding.  My 2008 650 was the same way until I did this adjustment.  Now it works fine.  It seems that a lot of them came from the factory with maladjusted e-brakes.  Just make sure you leave enough slack at the cable adjustment so the brake does not drag.  If it drags, it will get very hot and cause the rear diff lube to exit from the breather tibe and bellows under the rear bed.  I added a lenght of tubing to my breather and mounted the bellows up high behind my right seat along the cross bar.  This has stopped the diff lube dripping I was getting when the bellows was mounted in the factory location.

Hope this helps.


If the women don't find you handsome, then they should at least find you handy.

Offline

Board footer

Powered by FluxBB