You are not logged in.
hey guys i have a 500 efi 2006 ranger recently i took the back pull off the bigger pullyof the 2.... well after i took it off and took the c clip off and pulled the pully in half the spring tesion let lose now have no idea were it goes... it has number and 3 differnt holes to place the spring into .my qestion were does it go factory ..
i put it back twice and once was to tight i had to rev it hard o get it to move and the secondtime it was so lose no tension at all and i reved to the moon but no low end ......and all this was done in low range ..... so any info would help me out
Offline