You are not logged in.

#1 2008-07-05 19:54:40

lock1up
Member
Registered: 2008-07-04
Posts: 2

Re: 2008 rhino digital dash problem

"Someone" left the key in the on position and nearly drained the battery. When I tried to start it, it clicked, but was unable to turn over, thus draining the rest of the juice left in the battery. I charged the battery and now the dashboard display only shows a blinking "E". Does any body know what happened and how to fix it?  :cry:

Offline

#2 2008-07-14 22:57:59

mbroyles
Administrator
From: Phoenix, AZ
Registered: 2007-01-18
Posts: 563
Website

Re: 2008 rhino digital dash problem

did you find a fix for this yet?


Yamha Rhino Forum, Polaris Ranger Forum, Polaris RZR Forum. Your source for Side X Side Information and Entertainment.

Offline

#3 2008-07-15 07:29:14

lock1up
Member
Registered: 2008-07-04
Posts: 2

Re: 2008 rhino digital dash problem

The dash was fried.  I took it in and had to have it replaced.  It was covered under warranty. When I tried to start the rhino that last time the battery was so discharged it wouldn't turn the engine over, however it somehow had enough juice to cause the hour meter chip inside to fry.  Fried hour meter chip, no work.

Offline

#4 2008-07-15 17:28:58

MR. KRYPTONITE
Member
From: UTAH
Registered: 2007-01-21
Posts: 2,148

Re: 2008 rhino digital dash problem

Did they say what caused this to happen?


www.ruthlessmotorsports.com
Shop:801.737.6400
Cell:435.851.3637

Offline

#5 2008-08-09 10:19:26

jimrs
Member
From: Elm Grove, Louisiana
Registered: 2008-06-03
Posts: 3

Re: 2008 rhino digital dash problem

What type of charger and how many amps did you use to recharge the battery? Did you leave the key on while it was charging by mistake? Other than that I have no idea of what could have happened.

Offline

Board footer

Powered by FluxBB